| View previous topic :: View next topic |
| Author |
Message |
ngonping
Joined: 07 Nov 2008
Posts: 19
Location: London
|
 Posted: Sat Nov 08, 2008 12:41 am Post subject: double film holder |
 |
|
| a newbie question, how can i tell if i have the double cut film holders? mine are lisco. also there is a little rust on the pegs at either side. i got 3 free with the camera. |
|
| Back to top |
|
 |
alecj
Joined: 09 May 2001
Posts: 853
Location: Alabama
|
| Posted: Sat Nov 08, 2008 4:39 am Post subject: |
|
|
| Odds are you do have double film holders. Look for 2 handles on one end. Pull each out and you are pulling out a dark slide. 2 handles = 2 slots for film. The pegs you mentioned (2 of them, right?) are used to hold the dark slides in after the film is loaded. |
|
| Back to top |
|
|
Les
Joined: 09 May 2001
Posts: 2682
Location: Detroit, MI
|
| Posted: Sun Nov 09, 2008 12:49 am Post subject: |
|
|
Double cut film holders are roughly a 1/2 Inch thick and have two darkslides and are made of wood or plastic.
Single cut film holders are stamped sheet metal, are less than 1/4" thick and are usually found in European film sizes (9x12cm 12x13cm and occasionally 3 1/4 x 4 1/4)
_________________
"In order to invent, you need a good imagination and a lot of junk" Thomas Edison |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
